2S 330mAh LiHV hardcase battery
Produktnummer:
GL-LiHV330
Hersteller:
GL Racing
Herstellernummer:
GL-LiHV330
Produktinformationen "2S 330mAh LiHV hardcase battery"
[GL-LiHV330] 2S 330mAh LiHV hardcase battery
GL is going to
release our Hard Case LiHV Battery for mini scale chassis. It is
compatible to our GL own designed battery connector which can be plugged
into the battery “directly” as if you are using the pin plugs. At the
same time it can support pin plugs if you prefer to use pin plugs. No
matter which of the above mentioned plugs you are using, you are able to
enjoy the benefits of this Hard Case Battery:
1.
Battery producers usually making “extra” length of wire in order to
suit all chassis but this makes wires are jumping up in the chassis due
to they are too long. Now you can tailor made the length of wires coming
out from your car’s ESC to perfectly match each of your car setting
& chassis. Side benefit is reduced weight as less redundant wires.
2. The battery is able to sit into the car chassis properly without intervention by wires coming out from the battery.
3.
With the above mentioned 2 benefits, you will find your wires are more
tidily placed inside the chassis which have added advantage to the car
stability.
4. It is a high voltage battery that supports charging up to 8.6 voltage and gives you more power.
5. More durable indeed as the battery is protected by the hard case.
6. Battery size:43x20x13mm
Anmelden
Accessory Items
3x GL connector Parallel Charging Cable
19,80 €*
[PT0006] 3x GL connector Parallel Charging Cable
Details:
3x JST-PH Parallel charging cable
For GLA and Atomic AMZ/BZ Lipo batteries or any other 2S Lipo with a JST-PH connector.
This handy charge cable allows you to connect 4mm banana plugs to chargers, and the charger's balance board.
On the battery side, we have provided 3x JST-PH connectors so that you can charge/discharge up to 3 packs at a time.
You do not have to use all 3 of course, using it to charge 1 pack is perfectly fine, but if you would like charge/discharge up to 3 packs together, this cable can do it.
For those new to parallel charging, you can google/you tube information on it, but in summary:
You can only connect 2S Lipo to this cable
Mixing 300mAh, 330mAh, 360mAh together is ok
The packs should be reasonably similar in voltage, for example, 2 packs 90% full, 1 pack empty, is NOT such a good idea, as it will cause a lot of current(Amps) going from the full packs to the empty pack, charging the empty pack at very high current(AMps), this might even melt the cable if the Packs are large/high C enough.
All empty is fine, ~30%, ~40%, ~50% mix together is fine.
Ideally charger capacity set to total mAh of the packs
Charger current can scale up according to total capacity of the packs
